China black model Manufacturers, Suppliers, Factory

Automatic injection workshop, just at the end of the assembly line with a worker on the line, compared to manual, it can work more efficiently, save time and labor, the production speed is very fast.

Ultrasonic humidifier: Working Principle: Ultrasonic humidifiers use high-frequency oscillation (1.7MHZ) to atomize water into 1-5 micron ultra-fine particles. This approach not only freshens the air, but also promotes health, creating a comfortable and pleasant environment for you. Pure type humidifier: Working Principle: Pure humidifier adopts molecular sieve evaporation technology to effectively remove calcium and magnesium ions in water, which fundamentally solves the problem of “white powder”. It washes the air through the water curtain, purifies the air while increasing the air humidity, and finally sends the clean and moist air into the room through the wind device to enhance the overall humidity of the environment. Electrothermal humidifier: Working Principle: Electrothermal humidifier is based on the principle that electric current generates heat through electrical resistance, which converts electrical energy into thermal energy.

In principle, solar street lights are powered by solar energy, which can be charged by solar panels during the day.

Generally use 3~6 drops of essential oil, which can cover an area of 10-20 square meters, which is the size of a room. In special cases, the amount of essential oils can be increased. For example, when a newly renovated house wants to remove formaldehyde, 8 drops of purified essential oil can be used to incense.

1. Measure and Mark: Use the measuring tape to determine the center of the post or pillar. Mark the spot where the solar post cap light will be mounted using a marker or pencil. 2. Attach the Mounting Hardware: If the solar post cap light comes with mounting hardware (such as screws and brackets), attach them to the base of the light. Use the screwdriver or drill to secure the mounting hardware to the post or pillar, aligning it with the marked center spot. 3. Install the Solar Post Cap Light: Place the solar post cap light onto the mounting hardware. Secure it in place by tightening any screws or bolts provided. 4. Adjust and Test: Once installed, ensure the solar panel is facing upwards and is not obstructed by any shading. Turn on the light (if it has a switch) and test it to make sure it is working properly. Adjust the brightness or dimming settings if the solar post cap light has these features.

When choosing the installation location of solar wall lights, we suggest you consider the following points: Lighting conditions: Please try to choose a sunny, unobstructed wall to ensure that the solar panel can fully receive sunlight, thus improving the charging efficiency and length of use of the lamps and lanterns. Safety: Make sure the installation position of solar wall lights is stable to avoid the safety hazards caused by falling lamps. Lighting requirements: Determine the installation height according to your actual lighting requirements. Generally speaking, it is recommended to install it about 2 meters above the ground so that it can better illuminate the wall and the surrounding area. Aesthetics: Please consider the coordination between the soalr wall lights and the surrounding environment, and choose the appropriate installation position to enhance the overall aesthetics. We hope these suggestions will be helpful to you!